Topac Inc. The Instrumentation Compamy
You can purchase online 
where you see the check mark
 Click on the assistant to view the contents  of your shopping cart view shopping cart
 
 
Digital Panel Meters
Process Monitor
Asahi Digital panel meters from Asahi Keiki
offer impressive specifications, reliability
 and low cost for a variety of applications
 
AS104      Features
  • Adjustable offset +/ 1000
  • Full scale adjustable 100~1999 
  • Span Rang 200 counts
  • Leading zero suppression
  • Last digit suppression available
  • Analog output (isolated)(Option)
  • Excitation power supply 24VDC,  12V for transducer
  • Bright 14.2 mm red LED
  • AC 180-264V, 90~132 V
  • Variable conversion rate
AS104 Process Monitor
Specifications
Input Configuration Single Ended
Input Bias Current 2 nA typical
Conversion Rate 2.5 /sec (can adjust 0.3/sec to 2/sec)
Normal mode rejection > 50dB (50/60Hz)
Temp characterisitic < 100 ppm/degC
Display LED 14.2mm 3 1/2 digit
Polarity "-" automatic
Decimal point Set to any position
Over-range indication 0000 flashing
Full scale adjustment 100 - 1999
Offset adjustment +/- 1000
Span range 2000 counts
Zero Display leading zero suppression from front switch
Last Digit suppression Can fix 10e0 digit to "0" (internal jumper)
Hold -ve signal 0 volt or short
Excitation supply DC 24V +/-10%, 30 mA, DC12V +/- 10%, 60 mA
Power consumption 5 VA
Power Supply AC 90 - 130 Volts
AC 180 - 264 V
Operation temperature 0~ 50 C, 35 - 85% RH
Dimension mm H x W x D 48 x 96 x 144 mm DIN size
Weight Approx 450 gm 
Dielectric Strength Power supply terminal to input. output, gound, common and case AC 1500 Volts for 1 min.
DC Type
Input (lo) and power supply, DC +/- 500V
Insulation Resistance DC +/- 500V 100 MOhm at above terminals
 
Analog Output Specifications
Model Output Load Resistance
AS-104-_ _ 1V 1~ 5 V Min 1 K Ohm
AS-104-_ _ 2A 4~20 mA 0 ~ 600 Ohm
AS-104-_ _ 0V 0~1 V Min 500 Ohm
AS-104-_ _ 2V 0~5 V Min 1K Ohm
AS-104-_ _ 3V 0~10 V Min 1 K Ohm
AS-104-_ _ 4V 0~10 mV Min 10 K Ohm
AS-104-_ _ 5V 0~100 mV Min 100 K Ohm
AS-104-_ _ 0A 0~1 mA 0~ 12K Ohm
AS-104-_ _ 1A 0~10 mA 0 ~ 600 Ohm
AS-104-_ _ 3A 0~20 mA 0 ~ 600 Ohm
 
Accuracy 0.15% FS (23+/-5 degC)
Linearity 0.1% FS
Response Time less than 0.5 sec (0-90%)
Temperature Coefficient Less than 200ppm/degC
Adjustable range Zero: More than +/- 3% of Span
Span:More than +/- 3% of Span

 

DC Voltage Measurement
Accuracy +/- 0.1% of reading +/- 2 digit (23 C +/-5 C
Model Range Display
Adjustable
Input Impedance Input Protection view shopping cart
AS-104-1V 1-5 V Offset 
+/- 1000
Full-scale
100-1999
1 MOhm +/- 250 V  
AS-104-0V 0-1 V 100 MOhm +/- 250 V  
AS-104-2V 0-5 V 1 MOhm +/- 250 V
AS-104-3V 0-10 V 1 MOhm +/- 250 V
AS-104-5V 0-100 mV 100 MOhm +/- 250 V
 
DC Current Measurement
Accuracy +/- 0.1% of reading +/- 2 digit (23 C +/-5 C
Model Range Display
Adjustable
Internal
Resistance
Input Protection view shopping cart
AS-104-2A 4-20 mA Offset 
+/- 1000
Full-scale
100-1999
125 Ohms +/- 50 mA  
AS-104-0A 0-1 mA 100 Ohms +/- 50 mA
AS-104-1A 0-10 mA 100 Ohms +/- 50 mA
AS-104-3A 0-20 mA 50 Ohms +/- 50 mA
 
AS104 Process Monitor
 Click on diagram for larger image
Ordering Information
AS-104-rr-WX-YZ Use the part numbers above for the range rr and add the following final characters to designate the output WX, power supply 'Y' and excitation power supply Z view shopping cart
WX Affix   01 -None or $273.00  
1V ... 3A etc from analog output table above $362.00
Y Affix 1 AC 90~132V
Y Affix 2 AC 180~264V
Z Affix 2 Excitation supply DC24V
Z Affix 3 Excitation supply DC12V
 

Topac Inc. 231 CJC Highway, Suite 103 Cohasset MA 02025 USA
Tel: 781 740 8778 Fax: 781 740 8779
e-mail: sales@topac.com

| Home | E-mail | Online store | Inquiry form | Related |

This is a world wide web document page design layout and HTML code copyright ©1999 by Topac Inc. - ALL RIGHTS RESERVED